top of page

Irwin, PA

Serving Pittsburgh & Westmoreland County

How Much Topsoil Do You Need After Grading?

Writer: Dombrowski Projects
Dombrowski Projects
3 days ago
6 min read

After grading, a new lawn typically needs enough topsoil to leave a settled layer of at least 4 to 6 inches over the subsoil, according to Penn State Extension. How much topsoil you need to order then follows from the area you are covering and that finished depth.

 

Penn State Extension's Lawn Establishment guide (updated September 19, 2025) says, "Typically, a minimum of 4 to 6 inches (firmed or settled depth) of a good-quality topsoil is needed to establish good-quality turf," and that ideally 2 inches of it should be mixed into the upper 2 to 3 inches of the subsoil. Since a cubic yard is 27 cubic feet, one cubic yard of topsoil covers 81 square feet at 4 inches deep and 54 square feet at 6 inches, which works out to about 12.3 cubic yards per 1,000 square feet at 4 inches and 18.5 cubic yards at 6 inches. This post covers the math for your own yard, loosening compacted ground, screened topsoil and fill dirt, soil testing in Westmoreland County, and seeding times in Pennsylvania.


Dombrowski Projects - Blog Image

How Much Topsoil Do I Need in Cubic Yards?

 

Multiply the area in square feet by the depth in inches, then divide by 324. That number comes from 27 cubic feet in a cubic yard times 12 inches in a foot, and the answer is in cubic yards.

 

Here is a worked example. A backyard 50 feet wide and 100 feet deep covers 5,000 square feet. At 4 inches, that is 5,000 times 4 divided by 324, or about 61.7 cubic yards of topsoil. At 6 inches, the same yard needs about 92.6 cubic yards.

 

UConn Extension's soil lab gives a quick cross-check: "Estimate the amount needed by figuring 12 cubic yards will cover about 1000 square feet to the depth of 4 inches." A topsoil calculator runs the same arithmetic, so the input to get right is the depth.

 

Use the settled depth, not the loose depth. Penn State states its range as a firmed or settled depth and notes that rainfall or irrigation can settle the soil as an alternative to mechanical firming, so check the depth after the soil is firmed rather than right off the truck.

 

Should the Subgrade Sit Lower Than the Finished Lawn?

 

Yes. Penn State says the subgrade "should be lowered to account for the addition of several inches of topsoil," so the finished lawn lands at the planned grade. Grade stakes with colored ribbons can mark both the desired grade and the topsoil depth before the first load arrives.

 

Penn State also recommends that, if possible, "the grade should slope gently away from any building foundation at a 1 to 4 percent slope." On sloped lots around Irwin and North Huntingdon, set that slope in the subgrade so an even layer of topsoil keeps it.

 

Topsoil already on the site can shrink the order. Penn State's sequence starts site preparation after construction stops and before topsoil is put back, if it was removed and stockpiled before construction began. This post on what a grading contractor does for a property covers the grading side of that work.

 

Why Does Graded Ground Need Loosening Before Topsoil Goes Down?

 

Penn State Extension is direct about it: "Often, the subsoil at the site is severely compacted due to construction activities." Its guide says "A bulldozer equipped with a large hook called a ripper can break these soils apart and facilitate tillage and grading," and that slightly compacted soil "can be loosened with a chisel plow."

 

The same guide warns that bulldozers can compact the soil themselves and suggests, if possible, "a skid steer or tractor equipped with a grading blade or box scraper" instead. Rocks, stumps, lumber and large roots should come out first, since Penn State says they "will interfere with grading and tilling."

 

Penn State says tilling for most turf establishments should reach at least 4 inches deep, on moist but not wet soil. Blending the first 2 inches of topsoil into the loosened subsoil gives a gradual transition, and Penn State says this step "can reduce subsoil compaction and increase drainage at the topsoil-subsoil interface."

 

For the bigger picture on sloped lots, this overview of site grading on hillside terrain explains the grading process itself.

 

What Is Screened Topsoil, and Is Fill Dirt the Same Thing?

 

Screened topsoil is topsoil that has been sifted through a mesh to take out stones and rock fragments. UConn Extension's soil lab says screened topsoil "should be completely free of rock fragments greater than 3 inches in diameter (cobbles and stones)," that "Most soils are screened through a 3/4-inch mesh," and that topsoil should hold at least 2% organic matter but no more than about 10%.

 

According to UConn Extension in Connecticut, there are no legal marketing standards for topsoil, so ask the supplier what screen size was used and whether the organic matter has been tested.

 

On fill dirt vs topsoil, the two do different jobs. Pennsylvania's waste rules, at 25 Pa. Code 271.1, describe clean fill as inert material used to level an area or bring it to grade, which makes fill the layer that builds up the subgrade, while topsoil is the layer the new lawn grows in.

 

Why Test the Soil Before Seeding?

 

Penn State's lawn guide says, "The only way to determine how much fertilizer and lime are required for turf establishment is with a soil test," and recommends collecting samples three to four weeks before soil preparation begins. The university's Agricultural Analytical Services Laboratory analyzes each standard sample for pH, lime requirement, phosphorus, potassium, magnesium and calcium.

 

The lab says standard kits may be purchased from county offices of Penn State Extension, though a kit is not required because forms can be printed.

 

In Westmoreland County, the Penn State Extension office is at 214 Donohoe Road, Suite E, in the Donohoe Center in Greensburg, PA 15601. The phone is 724-837-1402, and hours are Monday to Friday 8:30 a.m. to 4:00 p.m.; the office asks visitors to call ahead.

 

Once results come back, Penn State says phosphorus and potassium should be tilled in before planting, but nitrogen should not be tilled in because it can leach; starter fertilizer goes on the surface just before or after seeding.

 

When Should You Seed After Grading in Pennsylvania?

 

Penn State Extension says, "In Pennsylvania, optimum times for turf seeding are mid/late spring and late summer/early fall." It explains the appeal of late summer this way: "When planted in late summer, seedlings will have two cool growing seasons (fall and spring) to become established." Summer seedings, it warns, "are subject to heat, drought, and disease problems."

 

Late fall is a poor bet. Penn State notes that "Seed will not germinate when soil temperatures become too cold in late fall," so ground graded in late fall or winter in Westmoreland County may have to wait for a mid to late spring seeding.

 

Straw mulch helps new seed hold; Penn State says rates of 80 to 100 lb of straw per 1,000 square feet are generally sufficient on level or gently sloping areas. Bare graded soil is exposed until grass fills in, and this post on erosion control after grading covers methods, slope and timing.

 

If the seeding window does not fit the schedule, this post on when to sod instead of seed, including ground prep compares the two.

 

FAQ

 

How much area does one cubic yard of topsoil cover?

 

Divide 324 by the depth in inches. One cubic yard covers about 162 square feet at 2 inches, 108 square feet at 3 inches, 81 square feet at 4 inches and 54 square feet at 6 inches.

 

Does topsoil settle after it is spread?

 

Yes. Penn State Extension writes its 4 to 6 inch recommendation as a "firmed or settled depth," so measure after mechanical firming or after rain or irrigation has settled the soil.

 

Can topsoil go straight onto compacted ground?

 

Penn State's guide calls for loosening it first: a ripper for severely compacted subsoil, a chisel plow for slightly compacted soil, then tilling at least 4 inches deep for most turf plantings before topsoil is blended in.

 

How deep should a lawn soil sample be?

 

Penn State's soil lab says to sample turf 2 to 3 inches deep, taking thin slices or borings from 12 or more locations. Discard the grass and thatch, mix the soil, air dry it without heat and send about 1 cup.

 

Do you need a permit to regrade a yard in Pennsylvania?

 

It depends on the size of the job and local rules. Under 25 Pa. Code 102.4, erosion and sediment best management practices apply to all earth disturbance and a written E&S Plan is required at 5,000 square feet or more, and 25 Pa. Code 102.5 requires an NPDES permit at 1 acre or more. Check with North Huntingdon Township, Irwin Borough, or your township or borough, and the Westmoreland Conservation District, before work starts.

 

Is darker topsoil better?

 

Not necessarily. UConn Extension warns that very dark gray soil may be dredged wetland soil that is acidic and poorly structured.

 

Grading and Lawn Care From Dombrowski Projects

 

Dombrowski Projects is a family-owned contractor based in Irwin, and its excavation services include grading, site clearing and soil removal and disposal for residential and commercial properties. Once the grass is in, its lawn care services cover weekly mowing, edging, fertilizing and weed control. Ask for a free estimate on grading work in Irwin, North Huntingdon or elsewhere in Westmoreland County.

 

Visit Dombrowski Projects or call 412-742-6226 today. Contact us for more information.


Dombrowski Projects Logo

 
 
 

Comments


bottom of page